TA的每日心情 | 无聊
2024-9-8 14:56 |
|---|
签到天数: 105 天 [LV.6]常住居民II
小白
- 积分
- 0
|
本帖最后由 poi2021 于 2022-3-18 10:49 编辑
在做code v 无热化的时候 流程还不太会 问一下哈1.常用镜框材料是铝材料的CTE怎么加进去，格式是什么样的哈
2.宏therm_en 里面的dn/dt 三个温度怎么加进去哈
比如我在宏里加上语句
rfd 20 ! passed temperature
env
tok ! Use available dN/dT data outside of defined
! range
tem #1
! Add appropriate ENV commands below for DN/DT, EXP, EXM, etc.
exp germlw 61
dn germlw 400 400 400
exp znse 75
dn znse 63 63 63
exp zns 66
dn zns 39.8 39.8
exp irg206 21.6
dn irg206 32.35 32.56 32.87
然后运行程序的时候出现以下结果
INPUT DN/DT VALUES ARE ASSUMED TO BE FOR
12000.0 10000.0 8000.0
ENV> tok ! Use available dN/dT data outside of defined
ENV> tem 20
ENV> exp germlw 61
ENV> dn germlw 400 400 400
ENV> exp znse 75
Warning: A material which is not used by this system has been requested
ENV> dn znse 63 63 63
Warning: Requested glass ZNSE is not used by this lens system
ENV> exp zns 66
ENV> dn zns 39.8 39.8
Error: Input of a constant is missing
Warning: Sequence aborted
DN/DT data is needed at one or more wavelengths for the following surfaces:
1, 3, 5
DN/DT is stored at only one temperature for the materials at these surfaces:
3
Your original lens data is being restored
直接运行 thermpik
得到如下结果哈
An error was encountered running THERM_ENV.SEQ
Verify that this macro runs correctly at both
the low and high temperature specifications
|
|
发表于 2022-3-17 19:07
发表于 2022-3-18 10:45
